Packaged solutions for waste stream concentration
Liquid and semi-liquid waste streams are an unavoidable aspect of many industrial processes, from energy production to food manufacturing; from chemical processing to wastewater treatment; systems which can reduce the volume and water content of such waste streams can not only cut disposal costs, but often turn a waste into a potentially valuable resource.
Evaporation is an efficient way of reducing the volume of effluents and wastes. HRS evaporation systems raise effluent, digestate or liquid waste to its boiling point so that water is evaporated and then condensed, thereby obtaining a concentrated end product and water. Forced re-circulation uses a pump to send the product through the evaporator at high speeds, ensuring that heat transfer rates remain high and the negative effects of fouling are limited.
There are three main types of HRS evaporation system:
HRS corrugated tube evaporation systems
These are designed for the evaporation of low viscosity effluents with reduced particle size, like wastewater, brines and effluents with low concentrations of organic solids. These systems utilize HRS K Series corrugated heat exchangers as evaporator modules, providing high heat transfer and good resistance against fouling.
HRS scraped surface evaporation systems
When concentrating fluids with elevated viscosities (which lowers heat transfer) or those which have a higher fouling risk, such as organic solutions with high dry matter concentration, HRS uses the HRS Unicus Series of scraped-surface heat exchangers.
HRS Digestate Concentration System
The HRS Digestate Concentration System (DCS) is specifically designed to reduce the volume of digestate from anaerobic digestion (AD) systems. In most situations the process utilizes surplus heat from the CHP engine. The DCS works by super-heating digestate in a vacuum to facilitate concentration, using evaporation to significantly reduce digestate volumes while, at the same time, increasing the nutrient content and commercial value.
The HRS DCS is a multi-effect system in which the steam produced from this first heating cycle is re-used as the heating media for the second, and subsequent, effects. After the final effect, the steam is condensed back into water and can then be used to dilute feedstock going into the front end of the digester, creating a completely closed loop system. The DCS is wholly self-sufficient – no energy or water is brought in or wasted, and everything is re-used.
Types of evaporation
In mechanical vapor recompression (MVR) systems, an additional compressor is used to increase the pressure and temperature of the water vapor or steam, which also provides the thermal energy source for the evaporation process. The only additional energy required is the electricity to power the compressor. This replaces the thermal energy used for evaporation with electrical energy and therefore increases efficiency.
In thermal vapor recompression (TVR) systems, high pressure boiler steam is combined with the recovered (evaporated) low pressure steam in a thermocompressor. This maximizes the use of the recovered steam and provide considerable energy savings when compared with the use of boiler steam alone.